1.Machine Body(All steel is from Shanghai BaoSteel)
The machine body is composed by foundation,top rail,slider block,working table,lower cylinder, upright column, locknut and adjusting nut. The precision is adjusted by adjusting nut and the locknut fixed on the top rail. Foundation, top rail, slider block are made in steel welded structure. The plate's material is Q235-A steel, wilding adopt CO2 protective welding, heat-treatment will be in procedure after welding to eliminate internal stress.
The outside of the machine main structure will be in good smooth, no obvious unevenness phenomenon ,welding seam formation ,welding slag and shed scar imagination. Compressor structure adopt optimization design by computer, It has good strength and stiffness.
2.Main Cylinder- Center components (Use casted formation one time)
The main cylinder is fixed to the top rail area by cylinder port shoulder and the big locknut. Lower end of the piston is connected by coupling flange, bolt and slider. The material of piston head is iron casting to act as guidance. The piston head has the imported YX type sealing ring in the opposite direction.The piston rod is provided with the O type sealing washer to divided the cylinder into to two cylinder with guidance sleeve,The guide sleeve excircle is provided O type sealing washer with the help of the flange and bolt locking to guarantee no any leakage and highly sel in cylinder.Cylinder flange is provided with a dust ring to ensure that the piston rod of the dust
3. hydraulic press machine Slider
The movement of the slider is achieved by four vertical column guidance.The guide sleeve between slider and vertical column is alloy material with good abrasion resistance and easy replacement measures after abrasion.The below platform has equipped with T type slot to make the mold stable ,the ***ailed dimension can be provided under the requirement.
4.Lifting cylinder
Lifting cylinder is a piston type cylinder equipped in the middle hold of the foundation to work for the
|
Home
